Friday, January 25, 2013

What Screws To Make Use Of With Cement Boards

Cement board backers are commonly used to cover walls, ceilings and floors over which another type of material will be installed, such as tile or poured cement. The boards create a barrier between the frame or exterior of the area and the new floor, and therefore must be strongly attached in place to prevent shifting or damage later.


Cement Board Screws


To attach cement boards to your fixtures, you must use screws designed specifically for cement board installation. Many cement board manufacturers provide or offer these screws with your purchase; you can also find them at hardware and home improvement retailers. The screws are finished with a special coating that allows them to resist corrosion, which can occur thanks to the alkali levels in the cement of the boards. They also feature small grooves directly under the screw head to allow them to dig into the cement board for better hold.


Nail Options


If you cannot find or do not have access to cement board screws, there are some types of nails you can use for installing the cement boards. If nails are the way you choose to go, use only galvanized or hot-dipped nails. These types of nails, also used in outdoor decking and roofing installations, have a similar corrosion-resistant coating that allows them to resist rusting or fading from moisture exposure --- or, in this case, from the alkali state of the cement board.


Installing


Install a fastener every 6 to 8 inches along the perimeter of the boards. In terms of cement board screws, the size of the screw you need will vary depending on the fixture or base to which you attach the board. Cement board attached to plywood or similar underlayment will hold with only 1 1/4-inch screws; for thick or heavy metal fixtures, use 1 5/8-inch screws. In general, 1 1/2-inch galvanized nails will hold the board firmly in place. For flooring or wall installation, some builders choose to apply a thin layer of thinset mortar under the cement board to prevent any shifting or expansion. Even if you use this extra adhesive, you should still apply the nails or screws.


What to Avoid


While cement board may look and feel a lot like drywall or Sheetrock, the makeup of the interior of the boards is completely different. Therefore, drywall screws or nails will not work for cement boards. The fasteners designed for use with drywall do not feature the corrosion- and alkali-resistant coating that enables the cement board or galvanized fasteners to last.








Related posts



    Laying tile is a good way to increase your home's equity and attractiveness, but it needs to be done properly so the tiles will lay flat. One of the best ways to achieve this is to use backerboard...
    Most tile installations require a carefully prepared surface to which the tiles can adhere. Fiber cement backer board provides just such a surface. As cured cement, it is strong, sturdy, long-last...
    If you're planning on tiling an old plaster wall, it might be a good idea to first install a layer of cement fiber board over the plaster. If the wall is in a bathroom, it's a virtual necessity. C...
    Durock cement board is the lightest (by weight) backerboard product available on the market. It can be installed by determined do-it-yourselfers rather than hiring a professional. This material is...
    Using cement fiber board as a mounting surface for ceramic tile creates a durable foundation.Installing cement fiber board in areas that are exposed to significant moisture, including kitchens and...