Plaque posters feature a sophisticated high-gloss finish.
Making a plaque poster involves taking a print image and permanently sealing it against a solid wood-framed backing with a thick resin compound. The finished piece will look as if it is sealed under heavy glass and will be fairly resistant to scratches, nicks and stains. Making a plaque poster is significantly more expensive than using a traditional poster framing technique and the finished piece can be quite heavy, depending on the size of the poster. Materials for this project can be found at craft and home improvement stores.
Instructions
1. Measure and cut a piece of ½-inch plywood that is 8 inches taller and wider than the poster to be framed. Use a wood shaping tool to round the edges and a sander to smooth the board.
2. Use a high-gloss black spray paint to paint the board. Allow the paint to dry between coats and continue applying until the surface is a full, solid black.
3. Center the poster on the painted board and secure it to the surface with a spray adhesive. Use a piece of cheesecloth to fully adhere all portions of the poster to the board.
4. Cover a flat, stable surface with a waterproof tarp or drop cloth and position the wood plaque on top.
5. Mix epoxy resin according to manufacturer's guidelines. For best results, mix enough resin for the entire project at once so you don't have to stop mid-way.
6. Pour the resin in a slow continuous stream on to the center of the poster. The resin will slowly spread to the edges. If it appears to settle or become thick in one area or is not covering the full surface, use the back of a wooden spoon to gently direct the resin in the direction you want it to go.
7. Lift each section of the board and tap lightly as needed to encourage the resin to flow into an even layer over the entire board and to eliminate bubbles.
8. Allow resin to dry until completely hard. Remove it from the canvas tarp and use a sander to even out any drips or rough spots along the board edges.
9. Apply picture hanging hardware to the back and display as desired.
Related posts
Hot-mopping involves applying asphalt cement in your shower.Hot-mopping is the process of applying hot tar to the floor of a shower pan when installing a shower. Once the thick layer of tar dries,...
Fiberglass mattingFiberglass sheets are fairly thin, and are usually used to wrap around corners and provide a cosmetically appealing finished look. Fiberglass mats, on the other hand, are very th...
That popcorn texture on the wall is tricky to paint.Sheetrock is a trademark name for drywall panels made by USG Corporation, though the term "sheetrock" has come to be used in popular s...
Cut DrywallWhether you're cutting a long straight piece of drywall, or taking out a piece to make room for a fixture such as an electrical outlet, make sure your measurements are correct and your...
Trim molding can be added to enhance a staircaseInstalling stair trim to your staircase can add a touch of elegance and detail to an otherwise ordinary staircase. Adding stair trim molding is a gr...
