Reduction of Sulfur and Other Particulates
Given the known health hazards from factory smokestack emissions, particularly those of coal-burning electric power plants, it is highly desirable to reduce the emissions at their source. One proven way of doing this is to install scrubbers in the emission system. The technology of scrubbers, which can remove a very large proportion of the sulfur dioxide from smokestack emissions, is constantly being refined. While one might imagine that scrubbers would be installed directly inside a smokestack, they can in fact be added at many points in or around it. Some scrubber installations require the addition of an entire building or complex to a coal plant.
A Chemical Reaction Converts the Sulfur
When soft coal or oil are ignited and burned, sulfur dioxide is produced. The main method of removing sulfur dioxide from emissions is to put the "flue gas" from industrial plants through a tank containing a sprayed mixture of powdered limestone and water. The resulting chemical reaction produces a synthetic form of the mineral gypsum, which can be adapted for use in concrete or drywall. This can be done in a few different ways. In a "wet scrubber," the untreated exhaust is sent through a spray chamber where fine water droplets knock down the harmful particulates. The water at the bottom of the chamber enters a miniature water treatment plant where the sediments are removed before the water is recycled to be used again. "Dry scrubbers" use a granulated solid material or electrostatic technology to intercept the particulates, creating a dry waste product. These are not as common as wet scrubbers because of their higher costs of installation. In either case, before the flue gas reaches the scrubber, it may first pass through a filter that consists of some type of cloth bag to catch large particles. A second filter may be installed to catch very small particles after the flue gas leaves the scrubber.
Environmental Concerns Persist, Even With Scrubbers
While the idea of recycling waste from scrubbers into reusable synthetic gypsum is appealing, this technique has not been universally adopted. Much of the waste extracted from flue gas by scrubbers is dumped back into the coal mines from which it originally came. Great environmental damage can be done if the highly poisonous sludge comes into contact with ground water. The tremendously concentrated wastes dissolve easily in water, including wells and aquifers for drinking water.
Related posts
BasicsAir scrubbers remove pollutants from air or smokestacks. Industrial scrubbers are divided into two categories, wet scrubbers and dry scrubbers.Both act in the smokestack and often use limest...
Power plants are major sources of air pollution.During the middle of the 20th century, people became aware of the dangers that air pollution posed to public health. The federal and state governmen...
Air pollutionThe best control measure, of course, is prevention. However, as long as there are fossil fuel emissions from our coal-burning factories and gas-burning automobiles, there will be air...
Sulfur dioxide and hydrogen sulfide are produced under natural and manmade conditions.Sulfur dioxide and hydrogen sulfide are sulfur-based chemical gases produced both through natural and industri...
Hard wire a smoke detector to rely on integrated power.A smoke alarm warns the occupants of a building to get out whenever there is a fire. Many popular smoke detectors operate on battery power bu...
