Installing drywall and tiles in a shower and tub area has to be done with care, because of the moisture present in bathrooms. It is important to use green drywall in moisture-prone bathrooms rather than regular drywall. Following this guide will help install waterproof drywall and tiles.
Instructions
Install Waterproof Drywall and Tiles in a Shower and Tub Area
1. Unscrew water faucets trim from tub/shower area
2. Use your flat bar and remove old tile
3. Remove all the old drywall. Using a utility knife cut the drywall edges at the locations of the drywall you want to remove. Knock a hole in the old drywall so you can remove it. Clean all drywall from wood studs and remove all nails/screws.
4. Cut new waterproof drywall to size and install by nails or screws. Nail drywall within one inch from bottom and top and three equally-spaced nails in between on each wood stud.
5. Using the 4 inch drywall knife, spread drywall compound on seams and inside corners about 1/8 to 1/4 inch thick about 2 inches wide making sure to fully cover the seams.
6. Using the drywall paper install on compound over seams and in the corners. You will need to fold the paper and install into corners at proper lengths. Using the 4-inch blade, press the paper into the compound and then squeeze the excess compound out so that it leaves an even and flat surface.
7. Let dry for 24 hours.
8. Spread wall glue on wall using the 1/8 inch trowel, starting on the back wall.
9. Install the tile starting on the shower or tub surface working from the left to right. Cut last tile as needed. You may need to adjust tiles to keep the grout lines straight and even. After the back wall is complete you can do the remaining walls the same way.
10. After 24 hours mix water and grout in a bucket according to the directions on the package, and spread into the grout lines with a grout trowel.
11. Wash off excess grout as needed leaving grout in grout lines but off of the tile.
12. Caulk all corners and tile to tub/shower surfaces.
Related posts
Install Durock in a ShowerDurock brand wall and floor application is designed to support tile surfaces, making it an ideal choice in a shower, where moisture-resistant tile applications can make a...
Installing a Bathroom Shower WallLet's face it: tile is in. And in many cases, it doesn't matter much if it is ceramic, porcelain or a natural stone tile that you use. People just love tile! Funct...
If you've had a single shower tile fall off, then you might want to simply apply thinset to the back, hold it a few seconds to allow it to dry and regrout in that area. If, however, you find that...
In terms of suitability for hanging tiles, drywall isn't perfect, but is often workable. It's smoother and flatter than plaster, which is good. But it's not waterproof like wetrock or cement board...
Putting drywall in a shower is necessary before installing shower tile.Drywall is a suitable underlayment material to use in a shower. However, although greenboard -- or gypsum board with a specia...
