Ceramic tiled floor
Ceramic tile, due to its ability to conduct and retain heat, is an excellent choice for installation on a radiant-heated floor. It is wonderful to step out of bed on a cold frosty morning and put your bare feet on a warm floor. Ceramic tile floors installed over radiant heat maintain a temperature between 80 to 85 degrees Fahrenheit. The heated ceramic tile floor retains long-lasting warmth and takes less energy to keep the floor at a comfortable temperature.
Instructions
Installing Ceramic Tile
1. Turn the radiant heating system off for 24 hours before applying the gypsum to the floor. Smooth a layer of lightweight gypsum over the electric heating cables or water tubing, using a trowel. Maintain an even depth of the gypsum and make it as smooth as possible. Use caution to avoid damaging the cabling or tubing. Allow it to dry for a minimum of 24 hours before beginning ceramic tile installation.
2. Measure an even distance from the starting wall and mark lines on the floor. Use a straight edge or a chalk line to connect the lines.
3. Spread thinset to an area approximately 3 square feet. Thinset dries quickly, only spread an area that you can comfortably apply tile to in about 15 minutes.
4. Set the ceramic tile onto the thinset using the drawn line as a guide. Place spacers at the tile corners as you work. Lift one of the tiles periodically to check that the entire back of the tile is coated evenly with mastic. If the tile does not show an even coating, you may need to press harder on the tile or apply additional thinset to the back of the tile to get good adhesion. Tap the tiles by using a hammer and a scrap piece of lumber to set the tiles evenly, and check with a straight edge or level for evenness across the top of the tile. Remove any thinset that squeezes up between the tiles; this removes a lot easier while it is still wet. Excess thinset between the tiles will interfere with the grout.
5. Apply all full tiles and allow the floor to dry 24 hours, before setting the cut edge tiles. Cut the edge tiles with a wet-saw or nippers. Do not be concerned if the edge of the cut tile that butts the wall is uneven, as the baseboard covers the rough edges. Apply thinset to the back of the cut edge tiles and press into place.
Grouting Ceramic Tile
6. Remove tile spacers. Spread grout over the ceramic tile, working it into the openings between the tiles. Use a damp grout sponge to remove excess grout from the surface of the tiles, avoid using too much water, because it will affect the quality of the grout. Keep a bucket of clean water handy to rinse the sponge, and change the water when it becomes murky. Use a grout tool to clean and smooth the grout joints.
7. Allow the grout to dry and wipe the ceramic tile with a dry sponge or towel to remove the grout haze from the tile.
8. Turn the radiant heat back on. Use a low setting and gradually increase to the preferred heat level.
Related posts
Ceramic tile can add a distinctive touch to interior walls."Gypsum wallboard" is another term for drywall, which is the most common material used for interior walls today. If you're inst...
Replacing old tile with new can be a do-it-yourself project.Putting ceramic tile around a bathtub is one of the easiest tile installation jobs a homeowner can tackle. The surface around the tub sh...
Diverse in its decorative qualities, vast in its uses, and a lot more cost-efficient than stone, ceramic tile tops the list for bath and kitchen surfaces---and also foyers and mud rooms. Creativel...
Choosing TileTo choose the right tile, consider the use and placement of the bathroom tile. If it is going to be on the floor, the main concern is its slickness. You should try and find tile that...
Drywall isn't generally recommended as a backing for tile. This is mostly because the drywall can flex somewhat and put stress on the tiled area. However, if you're planning to install ceramic til...
