Rock lath, a type of gypsum wallboard, is often used as a substitute for plaster and can be used as a top layer over metal ductwork. The material is similar to drywall and is typically 3/8 inch thick. To allow for proper ventilation and prevent mildew from growing in your ductwork, cut holes for your ductwork to breathe. It's important to wear thick gloves and safety goggles when using a drill and cutting rock lath.
Instructions
1. Outline the size of the hole that you wish to remove from the ductwork using a pencil or marker. A circle stencil may be used to achieve exact measurements.
2. Drill a starter hole using a 1/8-inch drill bit. The hole should be created just inside of the circle outline. Drill the same hole using a 3/8-inch drill bit to make a bigger hole.
3. Insert the tip of your snips into the hole.
4. Cut the ductwork using the metal snips, following the circular outline. Continue cutting along the trace line until the hole has been completely cut and removed.
Related posts
Cut holes in metal ductwork to change the configuration of your installation.The main line of ductwork in a duct system, referred to as the trunk line, carries conditioned air throughout your home...
Rock lath is a base used to support plaster. It is also commonly known as gypsum lath or button board. Rock lath is a common lath that builders use in commercial and residential construction today...
Cuttings holes in lath and plaster walls requires more work than wallboard walls.Lath and plaster walls were once a common way to finish interior surfaces. Plaster stayed cool in the summer and re...
You can repair sheet rock to look like new.Repairing holes in sheet rock can be accomplished with minimum effort. If your house has sheet rock to make up the walls, chances are you may have a hole...
Sheetrock is a gypsum panel (drywall) manufactured by USG Corporation. Drywall is a popular choice for finishing interior walls. Holes in drywall are often the result of a doorknob or other object...
