Drywall consists of plasterboard covered with paper on one side. Sometimes, after the drywall is installed, the paper can become loose. The paper is important because it provides a bond that helps protect the plaster from falling apart. Repairing drywall paper that has become loose is accomplished with a few materials and a little know-how. The entire job requires a couple of days, including drying time. The drywall can be painted or wallpapered after the repair is completed.
Instructions
1. Dig some joint compound out of the bucket with the 6-inch drywall knife. Only get a small amount of joint compound on the edge of the knife.
2. Spread the joint compound onto the loose paper in the direction that it is ripped so that it lays flat. Use the very edge of the knife to remove excess joint compound so that it is smooth as possible. Allow the joint compound to dry for 24 hours.
3. Sand the repaired area with a drywall sanding sponge to smooth out any ridges or bumps. Paint or wallpaper as desired.
Related posts
The corners formed between two panels of drywall are one of the most common places for cracking and bubbling to occur. Sometimes this is caused by the shifting of the house's frame because of seas...
A bubble in drywall is caused by either air or water that pushes out on the outer layer of the drywall. Many times this occurs on a joint where drywall tape was placed. A bubble in the drywall sho...
Repair drywall with tape and joint compound.Drywall is a plasterboard used throughout construction to provide a final layer on the inside of walls and ceilings. It can easily be painted and marked...
Cracks in drywall joints occur for several reasons. The settling of the home, shrinkage of the framing lumber or improper amounts of drywall compound behind the joint tape. Drywall joints are the...
Editor B, www.Flickr.comMost drywall problems can be repaired with basic drywall tools, paper drywall tape and joint compound. Do not use drywall mesh tape for repairs. Although it is easy to use,...
